Follow the steps below to install and use:

Make sure pump is turned OFF.

1. Remove the multiport cover from the filter tank.

2. Empty the filter tank (follow filter tank instructions).

3. Remove, clean, and inspect the standpipe and laterals for damage.

4. Put the standpipe and laterals back into the tank and center it in the opening.

5. Cover the opening of the standpipe with duct tape to prevent balls from falling into the pipe.

6. Add the Filter ball. 700g filter ball is equivalent to 25kg sand. Once filled, the filter ball should occupy approximately 2/3 of the tank.

7. Remove duct tape from standpipe. Reinstall the multiport cover on the filter tank.

8. Turn the pump ON in "filtration" mode and prime the pump.